IF YOUR SWING IS ALREADY ASSEMBLED REVIEW STEPS 2-4 AND MAKE SURE STEP 5 AND 6 ARE COMPLETED.
|1)||Hold the Swing Seat (A) vertically and insert the Uncoated Chains (B) through the channels on the bottom of the Swing Seat (A). |
Assembly Hint : A coat hanger may be used to help pull chain through the(B) swing seat.
|2)||A partial link of Uncoated Chains (B) should show at the end of the Swing Seat (A)|
|3)||Place the last coated link of the Coated Chain (C) onto each Harness (D) and slide it to the top of the Harness (D)|
|4)||Position Harness (D) vinyl hook openings facing to the outside of the Swing Seat (A) and insert the exposed links of Uncoated Chains (B) that is sticking out of the Swing Seat (A) on to the Harness (D) vinyl hooks.|
|5)||Place Swing Seat (A) upside down. Crimp Harness (D) vinyl hooks closed by placing Harness (D) on a hard surface with hook openings up and hammering hooks closed. The openings can also be closed by squeezing with pliers|
|6)||Inspect crimp - Close opening until parts are touching |
CAUTION: It is important that you crimp Harness (D) vinyl hook ends completely closed before using
WARNING: Failure to crimp the hooks could cause the seat to disengage from the chain, and the child could fall. Improperly closed hooks could cause serious injury or deep cuts.